Steps to relocate a upright piano

Pianos regularly make movers annual list of products that are most often damaged. Grand pianos are specifically troublesome. Practicing the following procedures for dismantling, padding and filling grand pianos will prevent damage, lower claims expenditure, and improve consumer fulfillment.

1) At least 3 individuals are required to handle an infant grand piano. If the infant grand piano requires to go up or down stairs or if a complete or concert grand piano needs to be carried, a minimum of four individuals are needed.

2) Always complete a precise and thorough stock. It might be required or more effective to use a visual stock to properly explain and reveal pre-existing damage.

3) As numerous parts are dismantled, please location all hardware in a properly identified parts bag and after that position the parts bag in a "Components Box".

4) Get rid of the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furnishings pad.

5) Disconnect the lid by removing the hinge pins. Have someone wiggle the lid, holding it opposite the hinge, while a 2nd individual works the pin loose. Please beware not to damage the wood with the pliers or with the pin itself. If necessary, cover the jaws of the pliers with a small fabric to assist prevent damage to the wood. Wrap the lid in a clean furnishings pad.

6) Remove the prop that holds the cover open and cover it in a clean furnishings pad. The prop has a hinge pin and is in two pieces.

7) Remove the pedal assembly and cover it in a tidy furniture pad. When eliminating the screws, please be careful not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by placing a piece of masking tape with the appropriate number on each rod.

8) Pad the piano by positioning a tidy rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to avoid it from tumbling open while you manage the piano. Keep in mind: Please make sure that the surface area of the piano is dust-free before padding it.

9) Position a piano board and connect the straps so that it is prepared to receive the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.

10) Remove the left front leg by positioning one individual below the piano at the left end of the keyboard. Be sure to have two individuals lifting the corner of the piano while the 3rd individual eliminates the leg. Keep in mind: Please be sure to note which legs were gotten Get More Information rid of from which positions considering that some pianos have legs that are not interchangeable.

11) Place the piano on the piano board by decreasing the "leg-less" end onto the board. Please be sure to raise the whole piano a little while finishing this maneuver to prevent unnecessary pressure on the staying, connected legs as the piano tips. Be sure that the piano is centered snugly against the brace at the end of the piano board.

12) Remove the two staying legs and cover them in clean furniture pads. These legs are held in place by a "crucial and slot" plan. To eliminate the leg, slide it inward toward the center of the piano until it comes out of the slot.

13) Protect the piano to the piano board by bringing completions of the straps together and securing them. Place folded burlap pads over the furnishings pads however under the straps to supply additional protection to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, tie the loose ends of the 2 straps together.

14) To move the piano over a flat, level surface area, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, utilize the piano board as a skid. After sufficiently padding the stairs for defense against house damage, put the keyboard end of the piano toward the bottom of the stairs. Connect a bulge strap to the top end of the piano board to avoid the piano from slipping.

16) To load the piano, leave it on the piano board and place it in a tier as the first base product with the keyboard dealing with the wall of the preceding tier. The very best location to pack the cushioned lid is between the piano and the preceding tier or in between the wall and the piano.

Grand pianos represent a considerable obstacle, they can be moved without damage by using common sense and practicing the procedures noted above.

Leave a Reply

Your email address will not be published. Required fields are marked *